SimplyRFiD

1. Press the button labeled "Setup/Exit" on the front of your printer.

2. Press the button labeled "Previous" (also marked with an arrow pointing towards the left) until the display on your printer shows "RFID TAG CALIB" with "-RESTORE      RUN+" below it.

3. Press the button labeled with a "-" (negative/minus)

4. Enter your password (typically "1234") by using the button labeled with a "+" (positive/plus) to increment the digit you're currently modifying, and the button labeled with a "-" (negative/minus) to change to the next digit.

5. Once you have entered your password entirely, press the button labeled "Next/Save", then press the button labeled with a "-" (negative/minus).

6. If successful, your display should flash "PROG POSITION RESTORED". In this case, press the button labeled "Setup/Exit", then the button labeled "Setup/Exit".