SimplyRFiD

The darkness may need to be adjusted in two places if your labels are printing too dark or too light. The first place is through the front panel of your printer. ...

If your printer is printing an unusually high number of VOID (RFID tags that can not be programmed properly) ensure that your printer is properly calibrated. See How to calibrate ...

I f your Zebra R110Xi does not fill the entire label it could mean that your printer is not fully calibrated, or that your driver settings are not set properly for ...

I f your Zebra R110Xi skips labels or prints on more than one label it could mean that your printer is not fully calibrated, or that your driver settings are not ...

1. Press the button labeled "Setup/Exit" on the front of your printer. 2. Press the button labeled "Previous" (also marked with an arrow pointing towards the left) until ...

1. Press the button labeled "Setup/Exit" on the front of your printer. 2. Press the button labeled "Setup/Exit" again, then increment to "Load Defaults" using the "+" (positive/plus). ...

This only applies to the R110Xi Rev 3 . The Rev 4 (released in 2010) fixes these issues. We expect the Rev 3 to be around a long ...

This can happen quite often with Zebra printers due to the design of their label sensors. There are two types of labels you can purchase from SimplyRFID in regards to sensor ...